Possible explanation and actionDescriptionMessage
None. This message indicates the
name of the configuration file for the
phone.
Name of the configuration file.XmlDefault.cnf.xml, or
.cnf.xml corresponding to the
phone device name
Display Ethernet Statistics Screen
The Ethernet Statistics screen displays information about the phone and network performance. Ethernet
Statistics Information describes the information that appears on this screen.
To display the Ethernet Statistics screen, follow these steps:
Procedure
Step 1
Press Applications .
Step 2
Select Administrator Settings.
Step 3
Select Status.
Step 4
Select Status > Ethernet Statistics. See Ethernet Statistics Information for a description of the Ethernet
statistics.
Step 5
To reset the Rx Frames, Tx Frames, and Rx Broadcasts statistics to 0, press Clear List.
Step 6
To exit the Ethernet Statistics screen, press Exit.
Ethernet Statistics information
The following tables describe the information in the Ethernet Statistics screen.
Table 44: Ethernet Statistics for the Cisco Unified IP Phone
DescriptionItem
•
In IPv4-mode, displays only the DHCPv4 state,
such as DHCP BOUND.
•
In IPv6-mode, displays only the DHCPv6 state,
such as ROUTER ADVERTISE., (GOOD IP).
•
In dual-stack mode, both DHCPv4 and DHCPv6
state information is displayed.
Draft comment: Refer them to the tables added in
step 3 above
DHCP state (IPv4 / IPv6)
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
235
Model information, status, and statistics
Display Ethernet Statistics Screen
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
