c) Attach the phone bracket by inserting the tabs into the mounting tabs on the phone. The phone ports should
be accessible through the holes in the bracket.
d) Secure the phone bracket to the IP phone with the machine screws.
e) Thread the handset cord (and headset cord, if using one). Reattach the cords and seat them in the clips that
are incorporated into the phone body.
Figure 12: Attach the Phone Bracket
Step 3
Attach the Ethernet cable to the 10/100/1000 SW network port and wall jack.
If you are connecting a network device (such as a computer) to the phone, attach the cable to the 10/100/1000
Computer (PC access) port.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
321
Cisco Unified IP Phone Wall Mount
Install Bracket for Phone with KEM
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
