For cables that terminate outside of the bracket, use the cable-access openings in the bottom of the bracket to
position the power cord and any other cable that does not terminate in the wall behind the bracket. The phone
and wall bracket openings together form circular openings with room for one cable per opening.
Figure 31: Attach Phone to Wall Bracket
Step 5
Proceed to Adjust Handset Rest, on page 324.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
341
Cisco Unified IP Phone Non-Lockable Wall Mount
Install Non-Lockable Wall Mount Kit for Phone with Key Expansion Module
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
