6-33
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 6 Cisco ASR 1006 Router Overview and Installation
Connecting a Terminal to the Cisco ASR 1000 Series RP Console Port
Figure 6-24 shows the ASR1013/06-PWR-DC power supply for the Cisco ASR 1006 Router.
Figure 6-24 Cisco ASR 1006 Router DC Power Supply (ASR1013/06-PWR-DC) Terminal Block and
Plastic Cover
Step 10
Remove the tape from the circuit-breaker switch handle, and move the circuit-breaker handle to the On
position.
Step 11 Move the circuit breaker switch to the On position.
This completes the procedure for connecting the DC power supply in the Cisco ASR 1006 Router.
Connecting a Terminal to the Cisco ASR 1000 Series RP Console
Port
The Cisco ASR 1006 route processor has an asynchronous serial (EIA/TIA-232) RJ-45 console port
labeled CON on its front panel. You can connect this port to most types of video terminals through use
of the console cable kit that is included with your Cisco ASR 1006 Router. The console cable kit
contains:
• One RJ-45 to RJ-45 crossover cable
• One RJ-45 to DB-25 (female) adapter
• One RJ-45 to DB-9 (female) adapter
1 Negative terminal 4 Plastic cover slotted area
2 Positive terminal 5 Terminal block plastic cover single screw
3 Terminal block plastic cover
This unit might have more than one power supply connection. All connections must be remov
-48/-60V 40A
253914
3
4
5
1
2
To Next Page
Loading...
