13-9
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 13 Cisco ASR 1000 Series Routers Power Up and Initial Configuration
Configuring the Cisco ASR 1000 Series Routers at Startup
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2 The first sections of the configuration script appear only at an initial system startup. On subsequent uses
of the setup facility, the script begins with a System Configuration Dialog as shown below: When asked
if you would like to enter the initial configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the
system, extended setup will ask you to configure each interface on the system.
Note Basic management setup configures enough connectivity for managing the system; extended setup will
ask you to configure each interface on the system. For detailed information about setting global
parameters, refer to the Cisco ASR 1000_Series Aggregation Services Routers Software Configuration
Guide.
Checking the Running Configuration Settings
To check the value of the settings you have entered, enter the show running-config command at the
Router#
prompt:
Router# show running-config
To review changes you make to the configuration, use the EXEC mode show startup-config command
to see the changes and copy run-start stored in NVRAM.
Saving the Running Configuration to NVRAM
To store the configuration or changes to your startup configuration in NVRAM, run the copy
running-config startup-config command:
Router# copy running-config startup-config
To Next Page
Loading...
Need help?
General
