Cisco ASR 1000 Series - Page 199

7-25
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 7 Cisco ASR 1004 Router Overview and Installation
Connecting Power to Cisco ASR 1004 Router
Figure 7-17 shows the Cisco ASR 1004 Router AC power supply.
Figure 7-17 Cisco ASR 1004 Router AC Power Supply
Note Shielded cables must be used to connect to the DB-25 alarm connector on both the AC and –48
VDC power supplies in order to comply with FCC/EN55022/CISPR22 Class A emissions
requirements. See the “How Cisco ASR1000-RP Alarm Monitoring Works” section on
page 2-20.
Step 5 Turn the power supply switch to the On position.
This completes the procedure for connecting AC input power.
Connecting –48 VDC Input Power to Cisco ASR 1004 Router
This section describes how to connect the –48 VDC power supply in the Cisco ASR 1004 Router.
1 AC power supply Standby switch 4 AC power supply fan
2 AC power supply LEDs 5 AC power inlet
3 DB-25 alarm connector 6 AC power supply handle
280184
OUTPUT INPUT
FAIL
OK OK
FAN
100V-240V~ 12A-5A
50-60Hz
ALARMS
60V
1A MAX
OUTPUT INPUT
FAIL
OK OK
FAN
100V-240V~ 12A-5A
50-60Hz
ALARMS
60V
1A MAX
1 2
34
6
5