Cisco ASR 1000 Series - Page 269

9-15
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Rack-Mounting the Cisco ASR 1002-F Router
Figure 9-11 Attaching the Cable-Management Brackets to the Cisco ASR 1002-F Router
Step 8
Screw the cable-management brackets to each side of the rack-mount brackets already attached to the
chassis. Use two screws for each cable-management bracket.
Step 9 Check that all the screws are securely tightened.
Go to the “Attaching a Chassis Ground Connection” section on page 9-23 to continue the installation.
Rack-Mounting the Cisco ASR 1002-F Router
The Cisco ASR 1002-F Router can be installed in an existing rack with equipment or in an empty rack
with no equipment. The chassis can be mounted in two equipment rack types:
• Two-post rack, 19-inch or 23-inch equipment rack. Inner clearance (the width between the inner
sides of the two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is
3.47 inches (8.8 cm). Airflow through the chassis is from front to back.
Note If you are using a two-post rack, secure the rack to the floor surface to prevent tipping and
avoid bodily injury.
• Four-post, 19-inch equipment rack. Inner clearance (the width between the inner sides of the two
posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches/8.8 cm).
Airflow through the chassis is from front to back.
The Cisco ASR 1002-F Router can be installed with both front or rear rack-mount brackets.
1 Cable-management bracket top screw hole
and bottom screw hole
3 Chassis front rack-mount bracket
2 Cable-management bracket “U” feature — —
274498
SP
A-
4XOC
3-
POS
S
TA
T
US
0
1
2
3
C/
A
A/
L
C
/A
A/
L
C
/
A
A/L
C
/
A
A
/L
0
2
3
1