Cisco ASR 1000 Series - Page 276

9-22
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Attaching the Cable-Management Bracket
Figure 9-16 shows the Cisco ASR 1002-F Router on a four-post rack.
Figure 9-16 Installing the Cisco ASR 1002-F Router on a Four-Post Equipment Rack
Step 6 Use a level to verify that the tops of the two brackets are level, or use a measuring tape to verify that both
brackets are the same distance from the top of the rack rails.
This completes the procedure for installing the chassis on a four-post rack. Proceed to the “Attaching the
Cable-Management Bracket” section on page 9-22 to continue the installation.
Attaching the Cable-Management Bracket
The cable-management brackets mount to each rack-mount bracket on the chassis to provide
cable-management to both sides of the chassis (parallel with card orientation). These brackets are screw
mounted to the rack-mount brackets to allow easy installation and removal of cables.
The cable-management brackets for the Cisco ASR 1002-F Router contain one independent
cable-management “U” features with two screws for each bracket.
Note Make certain that the cable-management bracket “U” feature is facing upwards when you attach it to the
chassis.
1 Rear rack equipment rail 3 Front rack-mount bracket ear and holes
2 Rear rack-mount bracket ear and holes 4 Front rack equipment rail
274499
SPA
-4
X
O
C
3
-
P
O
S
S
T
A
T
U
S
0
1
2
3
C
/
A
A
/
L
C
/
A
A
/
L
C
/
A
A
/
L
C
/
A
A
/
L
0
4
1
3
2