14-41
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing Cisco ASR 1000 Router eUSB Devices
Figure 14-31 Cisco ASR1000 Series RP eUSB Device Removal and Replacement
Step 3
Replace the Cisco ADR1000-RP into chassis and remove any external USB sticks.
Note Once the new eUSB is installed and BinOS has successfully booted, this verifies that the new eUSB is
functioning properly.
Step 4 Restore the backup copy of the startup-config and boot image to the eUSB device.
Router# copy nvram:startup-config stby-nvram:startup-config
Router# copy bootflash:asr1000rp1-adventerprisek9.02.01.00.122-33.XNA.bin
stby-bootflash:
Step 5 Verify that the Cisco ASR1000-RP1 is operating properly. Check that the internal hard drive LED
(labeled as DISK HD) is flashing green. To check if the LED flashes green, from the ROMMON or IOS
prompt, perform a:
dir harddisk
Step 6 To restore data after the internal hard drive replacement, type:
archive tar/xtrac tftp:usb0:asr1000.tar harddisk:
You have completed the replacement procedure for the eUSB device on a Cisco ASR1000-RP module.
1 Phillips screw 3 Standoff
2 eUSB connector — —
To Next Page
Loading...
