14-45
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing Cisco ASR 1000 Series Router 1 GB USB Flash Token Memory Stick
dir harddisk
Step 7 To restore data after the internal hard drive replacement, run the following command:
archive tar/xtrac tftp:usb0:asr1000.tar harddisk:
You have completed the replacement procedure for the eUSB device in the Cisco ASR 1001 Router.
Removing and Replacing Cisco ASR 1000 Series Router 1 GB
USB Flash Token Memory Stick
The Cisco ASR1000-RPs contain ports for a 1 GB flash token memory stick to store configurations or
Cisco IOS XE consolidated packages.
Figure 14-34 shows the USB port 0 or 1 connector on the Cisco ASR 1000 Series route processor for the
1 GB flash token memory stick.
Figure 14-34 Cisco ASR 1000 Series Route Processor 1 Token Memory Stick Port
Caution Do not remove a USB Flash memory module when issuing some file access command or a read/write
operation to the Flash memory module when it is processing. The router might reload or the USB Flash
memory module can be damaged. You can check to see if the USB activity LED on the Cisco
ASR1000-RP front panel is flashing, prior to the removal of the USB device
To remove and then replace a USB 1 GB flash token memory stick from a Cisco ASR1000-RP, follow
these steps:
1 Internal hard drive LED 4 USB0 and USB1 connectors
2 External USB Flash LED 5 Cisco ASR 1000 Series RP LEDs
3 Internal USB bootflash LED — —
01
DISK
BF
USB
HD
MIN
ACO
MAJ
STBY
ACTV
STAT
ASR1000-RP1
PWR
CRIT
280078
5
4
1
2
3
To Next Page
Loading...
