Cisco Catalyst 3750 Hardware Installation Guide

3-37
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Chapter 3 Switch Installation
Installing the Switch
• Run the setup program. See the “Completing the Setup Program” section on
page C-11.
• Connect to the front-panel ports. See the “Connecting to the 10/100 and
10/100/1000 Ports” section on page 3-51, the “Connecting to an SFP
Module” section on page 3-55, and the “Connecting to a XENPAK Module”
section on page 3-59 to complete the installation.
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference.
Table or Shelf Mounting
Follow these steps to install the switch on a table or shelf:
Step 1 Locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach
the four rubber feet to the recessed areas on the bottom of the unit.
Step 2 Place the switch on the table or shelf near an AC power source.
After the switch is mounted on the table, you might need to perform these tasks
to complete the installation, run the setup program, and access the switch:
• (Optional) Connect the switches in the stacks. See the “Connecting
StackWise Cable to StackWise Ports” section on page 3-38.
• Connect to the console port, and start the emulation software. See the
“Connecting to the Console Port” section on page C-7 and the “Starting the
Terminal Emulation Software” section on page C-9.
• Power on the switch. See the “Connecting to a Power Source” section on
page C-9. If the switches are stacked, see the “Powering Considerations”
section on page 3-15.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing