Cisco Catalyst 3750 Hardware Installation Guide

CHAPTER
2-1
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
2
Product Overview
The Catalyst 3750 family of switches—also referred to as the switches—are
stackable Ethernet switches to which you can connect devices like Cisco IP
Phones, Cisco Wireless Access Points workstations, and other network devices
such as servers, routers, and other switches. This chapter provides a functional
overview of the Catalyst 3750 switch models. These topics are included:
• Features, page 2-1
• Front Panel Description, page 2-4
• Rear Panel Description, page 2-23
• Management Options, page 2-28
Features
The switches can be deployed as backbone switches, aggregating 10BASE-T,
100BASE-TX, and 1000BASE-T Ethernet traffic from other network devices.
Refer to the switch software configuration guide for examples showing how you
might deploy the switches in your network.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing