Cisco Catalyst 3750 - Where to Go Next

3-61
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Chapter 3 Switch Installation
Where to Go Next
Where to Go Next
If the default configuration is satisfactory, the switch does not need further
configuration. You can use any of these management options to change the default
configuration:
• Start CMS as described in the switch software configuration guide, and
configure the switch as a member of a cluster or as an individual switch.
• Use the CLI to configure the switch as a member of a cluster or as an
individual switch from the console. Refer to the Catalyst 3750 Switch
Command Reference on Cisco.com for information on using the CLI with a
Catalyst 3750 switch.
• Start an SNMP application such as the CiscoView application.