Cisco Catalyst 3750 Hardware Installation Guide

1-15
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Chapter 1 Using Express Setup
Where to Go Next
Other Switch Home Page Features
These additional features are available from the switch home page, as shown on
the left menu bar in Figure 1-9 on page 1-14:
• Cluster Management Suite—Launch the CMS, through which you can
configure and monitor a switch or switch clusters, display network topologies
to gather link information, and display switch images to modify switch- and
port-level settings. For more information, refer to the switch software
configuration guide.
• Tools—Access diagnostic and monitoring tools such as Telnet and Extended
Ping.
• Help Resources—Access Catalyst 3750 documentation.
Installing or Connecting Devices to the Switch
For detailed installation procedures on mounting your switch on or under a desk
or on a wall, or connecting devices to the switch, see Chapter 3, “Switch
Installation.”

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing