Cisco Catalyst 3750 - Configuring the Switch with the CLI-Based Setup Program

C-1
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
APPENDIX
C
Configuring the Switch with the
CLI-Based Setup Program
This appendix provides a CLI-based setup procedure for a standalone switch or a
switch stack. Before connecting the switch to a power source, review the safety
warnings in Chapter 3, “Switch Installation.”
Note For detailed installation procedures on rack-mounting your switch, stacking your
switches, or connecting to small form-factor pluggable (SFP) or XENPAK
modules, see Chapter 3, “Switch Installation.” For product overview information,
see Chapter 2, “Product Overview.”
These steps describe how to do a simple installation:
1. Accessing the CLI, page C-2
2. Taking Out What You Need, page C-4
3. Stacking the Switches (Optional), page C-5
4. Connecting to the Console Port, page C-7
5. Starting the Terminal Emulation Software, page C-9
6. Connecting to a Power Source, page C-9
7. Entering the Initial Configuration Information, page C-11