Cisco Catalyst 3750 Hardware Installation Guide

3-55
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Chapter 3 Switch Installation
Connecting to an SFP Module
Figure 3-45 Connecting to an Ethernet Port
Connecting to an SFP Module
This section describes how to connect to SFP modules. For instructions on how to
connect to fiber-optic SFP modules, see the “Connecting to 1000BASE-T SFP
Modules” section. For instructions on how to connect to 1000BASE-T SFP
modules, see the “Connecting to 1000BASE-T SFP Modules” section.
For instructions about how to install or remove an SFP module, see the “Installing
and Removing SFP Modules” section on page 3-41.
SYST
RPS
MASTR
STAT
DUPLX
SPEED
STACK
MODE
1X
2X
11X
12X
1
2
3
4
5
6
7
8
9
10
11
12
86818

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing