Cisco Catalyst 3750 Hardware Installation Guide

1-13
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Chapter 1 Using Express Setup
Rerunning Express Setup
Rerunning Express Setup
If you did not click Save at the end of the Configuring the Switch section, you can
rerun Express Setup by clicking Express Setup on the Switch home page.
If you have entered a wrong IP address or need to change the IP address of your
switch, you can clear the IP address on your switch by following the steps in the
“Clearing the Switch IP Address and Configuration” section on page 4-2.
Verifying Switch IP Address
This procedure is optional. After you have installed the switch in your network,
follow these steps to verify the IP address configured on your switch:
Step 1 Launch a web browser on a PC or workstation that is connected the network.
Step 2 Enter the IP address of your switch (for example: 172.20.139.142.) The switch
home page appears, as shown in Figure 1-9.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing