Cisco Catalyst 4500 Series

2-80
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
PORTFANOUTASIC8X100MAN Messages
PORTFANOUTASIC8X1000HW-7
Error Message C4K_PORTFANOUTASIC8X1000MAN-7-LOSTPACKET: [char] port [dec] lost one
or more packets, [dec] transmitted [dec] received
Explanation
A loopback packet was lost during online diagnostics of the module ASIC [char].
Recommended Action This is an informational message only. No action is required.
PORTFANOUTASIC8X100MAN Messages
This section contains the Port Fan-out ASIC 8x100 Manager (PORTFANOUTASIC8X100MAN)
messages. This ASIC takes a gigabit port and fans it out to eight 100-Mb ports.
PORTFANOUTASIC8X100MAN-4
Error Message C4K_PORTFANOUTASIC8X100MAN-4-DIAGSFAILED: [char] failed diagnostics
Explanation
The module ASIC that is identified by [char] failed diagnostics.
Recommended Action Contact your technical support representative.
Error Message C4K_PORTFANOUTASIC8X100MAN-4-FAILEDTOSENDLOOPBACKTRIES:[char] port
[dec] failed to send packet in [dec] tries
Explanation
The module ASIC [char] was unable to send a loopback packet on the module ASIC
port [dec] for the decth time. The switch has insufficient memory; it will attempt to send a loopback
packet up to three times.
Recommended Action Contact your technical support representative.
Error Message C4K_PORTFANOUTASIC8X100MAN-4-UNEXPECTEDLOOPBACK:
[char] sent out a loopback packet on port [dec], but it came back on port [dec]
Explanation The module ASIC diagnostics for [char] sent the loopback packet out port [dec] and it
came back on another interface [dec]. This condition is rare because the loopback is internal to the
hardware.
Recommended Action Contact your technical support representative.