EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #82 background imageLoading...
Page #82 background image
2-62
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IPROUTEMAN Messages
Error Message C4K_IPROUTEMAN-3-VRFMANDUPLICATEVRF: Tried to create a duplicate VRF
for key [object-info]
Explanation
A request was made to add a duplicate VRF.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-VRFMANNONEXISTENTDELETION: Attempted to delete VRF
with key [object-info] which does not exist
Explanation
A request was made to delete a VRF that does not exist.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-WCCPMALLOCFAILURE: WCCP service group [char] could
not be setup for redirection due to memory allocation failure.
Explanation
The service group cannot be set up for redirection in hardware because of failure to
allocate memory. The traffic that is expected to be redirected by this service group will be routed
normally. This condition might occur under extreme ACL, QoS, PBR, VRF, or other L2/L3 feature
configurations.
Recommended Action Try removing the unused or unneeded configuration on the switch before
attempting to configure the service group again. Please note that even though the service group
configuration shows up in the CLI, it has failed to be set up in hardware. Therefore, the service group
should be unconfigured before configuring it again. If the above does not help, please contact Cisco
Technical Assistance for further troubleshooting and resolution of the problem.
IPROUTEMAN-4
Error Message C4K_IPROUTEMAN-4-CANTALLOCATEFIBENTRY: FIB: No memory available to
allocate FIB Entry
Explanation
The switch has insufficient memory to allocate space for the route that is associated with
this network.
Recommended Action Install additional memory.
Error Message C4K_IPROUTEMAN-4-VRFMANCANTALLOCATEVRF: No memory available to
allocate VRF for key [object-info]
Explanation
The switch has insufficient memory to allocate space for VRF.
Recommended Action Install additional memory.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals