EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
2-57
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
C4K_IOSREDUNDANCYMAN Messages
C4K_IOSREDUNDANCYMAN Messages
This section contains the Catalyst 4500 series Cisco IOS module Redundancy Manager
(IOSREDUNDANCYMAN) messages.
Error Message C4K_IOSREDUNDANCYMAN-3-CHECKPOINTMESSAGESENDFAILURE:RkiosCheckpointM
an:Message send failure (client:[char])
Explanation
There was an internal error when allocating resources for the checkpoint facility.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSREDUNDANCYMAN-3-NEWCHECKPOINTCLIENTFAILED:RkiosCheckpointMan:
Error adding new client (client:[char], error:[dec])
Explanation
There was an internal error when allocating resources for the checkpoint facility.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSREDUNDANCYMAN-3-NEWCLIENTREGISTRATIONFAILED:RkiosRedundancyMa
n:Error adding new client (client:[char], error:[dec])
Explanation There was an internal error when allocating resources for the redundancy facility.
Recommended Action This is an informational message only. No action is required.
IOSSYS Message
This section contains the Catalyst 4500 series IOS system (IOSSYS) messages.
IOSSYS-3
Error Message C4K_IOSSYS-3-BLANKSTARTUPCONFIG: Blank or invalid startup-config
Explanation
An empty or invalid startup-config file was found in the NVRAM. The switch is booting
up with default settings.
Recommended Action Configure the switch and save the configuration to NVRAM as the startup file
for the next reboot. If the problem persists, contact your technical support representative.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals