Cisco Catalyst 4500 Series Message Guide

2-88
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
S2W Messages
Error Message C4K_REDUNDANCY-6-SWITCHOVER:Switchover activity detected
Explanation
The standby supervisor engine detected switchover activity.
Recommended Action This is an informational message only. No action is required.
S2W Messages
This section contains the Calendar (SERVICECARDMAN) messages.
Error Message C4K_S2W-4-READCALENDARERR: Calendar read operation Failed
Explanation
The calendar read operation failed.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_S2W-4-STARTCALENDAROSCILLATORERR: Failed to start the calendar
Explanation
The calendar operation failed to start.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_S2W-4-WRITECALENDARERR: Calendar write operation Failed
Explanation The system was unable to write to the calendar.
Recommended Action This is an informational message only. No action is required.
SFF8472 Messages
This section contains the floating-point subsystem (SFF8472) messages.
SFF8472-2
Error Message SFF8472-2-NOMEM: Not enough memory available for [char]
Explanation
The SFF8472 subsystem could not obtain the memory that it needed.
Recommended Action Contact your technical support representative.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E