Cisco Catalyst 4500 Series Message Guide

2-44
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSDHCPSNOOPMAN Messages
IOSDHCPSNOOPMAN Messages
This section contains the Catalyst 4500 series Cisco IOS DHCP Snooping Manager
(IOSDHCPSNOOPMAN) messages.
Error Message C4K_IOSDHCPSNOOPMAN-4-CANNOTADDNEWIPLIST: Cannot add new IP list for
dhcp security on [char] and vlan [dec]
Explanation
The switch attempted to add a new IP address to the list of permitted IP addresses but
failed. The new addresses are not permitted.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSDHCPSNOOPMAN-4-CANNOTENABLESECURITY: Cannot enable dhcp
security on [char] and vlan [dec]
Explanation
The switch failed to enable IP source guard on the interface and indicated VLAN. This
error probably occurred because there might be too many interface-VLAN pairs that have the feature
enabled.
Recommended Action This is an informational message only. No action is required.
IOSIGMPSNOOPMAN Messages
This section contains the Catalyst 4500 series Cisco IOS IGMP Snooping Manager
(IOSIGMPSNOOPMAN
) message.
Error Message C4K_IOSIGMPSNOOPMAN-3-NOSPACELEFT:No igmp group memory to add new
group entry
Explanation
There is insufficient memory to support additional IGMP group entries, which are added
automatically when you run CGMP or IGMP.
Recommended Action Install additional memory, or reduce the number of IGMP groups.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E