Cisco Catalyst 4500 Series Message Guide

2-79
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
PORTFANOUTASIC8X1000HW Messages
PORTFANOUTASIC8X1000HW Messages
This section contains the Port Fan-out ASIC 8x1000 Hardware (PORTFANOUTASIC8X1000HW)
message. This ASIC takes a gigabit port and fans it out to eight 1000-Mb ports.
PORTFANOUTASIC8X1000HW-3
Error Message C4K_PORTFANOUTASIC8X1000HW-3-UNKNOWNDEVICEID: [char] - Linecard
Management Protocol info register has unknown device id [hex]
Explanation
Each module ASIC has an information register on it that contains the device ID field
(DID) of the ASIC. When the module ASIC driver read this register, it discovered that the DID type
was invalid.
The [char] field of the DID might contain <asic-code>(x) where x is the gigabit port of the switching
engine to which the module ASIC is attached. The hex field of the DID contains the device ID. The
expected value is 0x0450.
Recommended Action Contact your technical support representative.
PORTFANOUTASIC8X1000HW-4
Error Message C4K_PORTFANOUTASIC8X1000MAN-4-DIAGSFAILED: [char] failed diagnostics
Explanation
The module ASIC identified by [char] failed diagnostics.
Recommended Action Contact your technical support representative.
Error Message C4K_PORTFANOUTASIC8X1000MAN-4-FAILEDTOSENDLOOPBACKTRIES: [char] port
[dec] failed to send packet in [dec] tries
Explanation
The module ASIC [char] is unable to send a loopback packet on the module ASIC
interface [dec] and this is the decth time that it has tried to send and failed. The switch attempts to
send a loopback packet only up to three times. The switch is out of memory.
Recommended Action Contact your technical support representative.
Error Message C4K_PORTFANOUTASIC8X1000MAN-4-UNEXPECTEDLOOPBACK: [char] sent out a
loopback packet on port [dec], but it came back on port [dec]
Explanation
The module ASIC diagnostics for [char] sent a loopback packet out interface [dec] and
it came back on another interface [dec]. This condition is unexpected because the loopback is
internal to the hardware.
Recommended Action Contact your technical support representative.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E