EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #118 background imageLoading...
Page #118 background image
2-98
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
STORM_CONTROL Messages
Error Message C4K_SUPERVISOR-3-SUPOCTALPHYMDIOREADERR: Failed to perform read
operation on Octal Serdes at address [dec] for the register at address [dec]
Explanation
There was an error with the Octal Serdes on the supervisor engine.
Recommended Action If this continues to happen, please contact your technical support
representative to replace the supervisor engine.
STORM_CONTROL Messages
This section contains the broadcast storm control (STORM_CONTROL) messages.
Error Message STORM_CONTROL-3-FILTERED: A [char] storm detected on [char]. A packet
filter action has been applied on the interface.
Explanation
The amount of traffic detected on the interface exceeded the configured threshold
values. The system filters excess traffic when a packet is received. The system is not forwarding
packet traffic.
Recommended Action Determine and fix the root cause of the excessive traffic on the interface.
Error Message STORM_CONTROL-3-SHUTDOWN: A packet storm was detected on [char]. The
interface has been disabled.
Explanation The amount of traffic detected on the interface exceeded the configured threshold
values. Because the interface was configured to be shut down if a packet storm event is detected, it
was placed in an errdisable state.
Recommended Action If automatic recovery is preferred, the errdisable recovery mechanism can be
used. Determine and fix the root cause of the excessive traffic on the interface.
STORE Messages
This section contains the storage (STORE) message.
Error Message C4K_STORE-2-OUTOFCHUNKS:Out of chunks of memory
Explanation
The system has insufficient memory.
Recommended Action Reboot the switch. If this message reoccurs, add additional memory.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals