Cisco Catalyst 4500 Series Message Guide

2-66
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
L3HWFORWARDING Messages
Error Message C4K_L3HWFORWARDING-3-PBRNOPBRCAMLEFT: K2FibPbr: attempted addition of
[dec] blocks to PBR cam region failed, only managed to get [dec] for FRM [char]
Explanation
There is insufficient memory to program a new route map.
Recommended Action Remove unused portions of the configuration to free the needed memory.
Error Message C4K_L3HWFORWARDING-3-PBRPUNTINGPORT: Policy routing exceeded maximum
TCAM usage, all IP unicast traffic on interface [char] will be switched in
software.
Explanation
The hardware policy-based routing forwarding engine has insufficient resources to
handle the route map for the specified interface. All unicast IP traffic for that interface will be
switched in the software instead.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_L3HWFORWARDING-3-WCCPMALLOCFAILURE: WCCP service group [char]
could not be setup for redirection due to memory allocation failure.
Explanation The service group cannot be setup for redirection in hardware because of failure to
allocate memory. The traffic that is expected to be redirected by this service group will be routed
normally. This condition might occur under extreme ACL, QoS, PBR, VRF, or other L2/L3 feature
configurations.
Recommended Action Try removing the unused or unneeded configuration on the switch before
attempting to configure the service group again. Please note that even though the service group
configuration shows up in the CLI, it has failed to be set up in hardware. Therefore, the service group
should be unconfigured before configuring it again. If the above does not help, please contact Cisco
Technical Assistance for further troubleshooting and resolution of the problem.
L3HWFORWARDING-4
Error Message C4K_L3HWFORWARDING-4-FLOWCACHEOUTOFSPACEFORFLOWCACHEENTRY:
K2FibFlowCache: insufficient space to store flow of type [object-info] with label
[packet-info]
Explanation
The software cannot load a flow cache entry into the hardware due to insufficient
memory.
Recommended Action This is an informational message only. No action is required.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E