2-72
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
PM Messages
PKTPROCESSING-7
Error Message C4K_PKTPROCESSING-7-ADJLOOKUPFAILED:Draining the backed up packets in
CPU queue when we cleaned up FIB adjacencies. Last drained packet's source address
[ip-addr] and destination address [ip-addr]
Explanation
This event can occur when the software processes the routed packets and the router port
is shut down. The software can automatically repair adjacencies, but there was at least one packet
in the queue that was lost.
Recommended Action This is an informational message only. No action is required.
PM Messages
This section contains the Port Manager (PM) messages.
PM-2
Error Message PM-2-LOW_SP_MEM: Switch process available memory is less than [dec]
bytes
Explanation
The switch has insufficient memory for processing. Too many Layer 2 VLANs might
have been configured in the system.
Recommended Action Remove Layer 2 VLANs or other features from the system to reduce memory
usage.
Error Message PM-2-NOMEM:Not enough memory available for [char]
Explanation
The Port Manager subsystem cannot obtain sufficient memory for the specified PM
operation. [char] is the PM operation ID.
Error Message PM-2-VLAN_ADD:Failed to add VLAN [dec] - [char].
Explanation
The VLAN was not added to VTP, because of the reason stated in the text string.
Recommended Action This is an informational message only. No action is required.
To Next Page
Loading...
Need help?
General
