Cisco Catalyst 4500 Series

2-14
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
COMMONSTUBMAN Messages
Error Message C4K_COMMONHWACLMAN-4-PORTBASEDACLSDISABLED: Output Port Acl [char]
has been disabled on port [char]
Explanation
The output port ACL is disabled on the interface because there are not enough hardware
resources or there are ACEs that require CPU processing of packets.
The port ACL is disabled and displays a warning message because the software cannot handle the
output port ACLs.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_COMMONHWACLMAN-4-PUNTTOSOFTWARE:Out of resources, punt packets to
sw for [object-info]
Explanation
The hardware content-addressable memory (CAM) resources have been depleted. The
hardware forwards the packets to the software for ACL processing.
Recommended Action Remove unnecessary ACLs from some interfaces.
COMMONSTUBMAN Messages
This section contains the Catalyst 4500 series ASIC-specific messages.
C4K_COMMONSTUBMAN-4
Error Message C4K_COMMONSTUBMAN-4-DIAGSFAILED: [char] failed diagnostics
Explanation An ASIC in slot [char] failed diagnostics.
Recommended Action Contact your technical support representative.
Error Message C4K_COMMONSTUBMAN-4-FAILEDTOSENDLOOPBACKTRIES: [char] port [dec]
failed to send packet in [dec] tries
Explanation An ASIC in slot [char] was unable to send a loopback packet on port [dec] and this is
the [dec]th time it tried to send and failed. This suggests that the switch is out of memory. The
software will attempt to send a loopback packet only three times.
Recommended Action Contact your technical support representative.
Error Message C4K_COMMONSTUBMAN-4-UNEXPECTEDLOOPBACK: [char] sent out a loopback
packet on port [dec], but it came back on port [dec]
Explanation
The ASIC diagnostics for slot [char] sent a loopback packet out port [dec] and it came
back on another port [dec]. This is unexpected because the loopback is done within the hardware.
Recommended Action Contact your technical support representative.