EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
2-42
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
ILCPROTOCOLERROR Messages
IDBMAN-6
Error Message IDBMAN-6-VLANMAPPED:Vlan [dec] is mapped to [char]
Explanation The given VLAN was mapped to the specified interface.
Recommended Action This is an informational message only. No action is required.
ILCPROTOCOLERROR Messages
This section contains the ILC Protocol (ILCPROTOCOLERROR)message.
Error Message C4K_ILC-3-PROTOCOLERROR: Service Module failed S2W protocol, error
[dec], state [dec]
Explanation
The Serial 2-Wire (S2W) communication with an intelligent line card deviated from the
defined protocol.
Recommended Action This is an informational message only. No action is required.
IOSACLMAN Messages
This section contains the Catalyst 4500 series Cisco IOS ACL management (IOSACLMAN) messages.
Error Message C4K_IOSACLMAN-4-ACLTYPEMISMATCH: Acl RkiosSharedIos[char] was earlier
attached as [char] Acl. Please unconfigure all its uses before using it as a [char]
Acl
Explanation
This message displays if you attach a named ACL as one type, delete the ACL, and
configure an ACL of a different type with the same name. For example, you configure a named IP
ACL using the name DefaultAcl, attach it to a router port, and then delete the ACL DefaultAcl by
entering no ip access-list extended DefaultAcl. You could configure a MAC ACL using the same
name. This message is displayed when you try to configure any ACEs in the MAC ACL.
Recommended Action Remove all configurations where the ACL is used as an IP ACL before
configuring a MAC ACL with the same name.
Error Message C4K_IOSACLMAN-4-MOLACLALLOCFAILURE: Mol Acl Allocation for [char] is
failed
Explanation
A new MOL ACL was created but there was insufficient memory for a MOL ACL. The
ACL was not applied.
Recommended Action Remove all configurations where the ACL is used as an IP ACL before
configuring a MAC ACL with the same name.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals