Cisco Catalyst 4500 Series Message Guide

2-59
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSSYSMAN Messages
IOSSYSMAN Messages
This section contains the Catalyst 4500 series Cisco IOS System Manager (IOSSYSMAN) messages.
IOSSYSMAN-0
Error Message C4K_IOSSYSMAN-0-FATALERRORCRASH:Forced crash due to: [char]
Explanation
The system is unusable due to software or hardware failures.
Recommended Action Analyze the memory dump, if any, and determine the cause of the failure, or
contact your technical support representative.
IOSSYSMAN-3
Error Message C4K_IOSSYSMAN-3-ENVVARNAMETOOLONG:Name of environment variable
Explanation The environment variable name is too long.
Recommended Action Enter the unset command to shorten the name.
Error Message C4K_IOSSYSMAN-3-OUTOFPACKETHEADERS:Cannot allocate buffer for a packet
header
Explanation The system cannot allocate a buffer for the packet header.
Recommended Action Contact your technical support representative, and provide the configuration
information for the switch.
IOSSYSMAN-4
Error Message C4K_IOSSYSMAN-4-ENVVARTOOLONG: Value of env. variable [char] is too
long
Explanation The software writes certain configuration values to the NVRAM. The variable name is
too long (greater than 4096 bytes) for the available storage space.
Recommended Action Boot the system into ROMMON mode. At the ROMMON prompt, enter the
unset command to change the environment variable name to a shorter name.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E