Cisco Catalyst 4500 Series Message Guide

2-49
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSIPROUTEMAN Messages
Error Message C4K_IOSIPROUTEMAN-3-PBRDOESNOTSUPPORTQOS:Route-map ' [char] ' on
interface ' [char] ' specifies Quality of Service rewriting which is not supported
via Policy-Based Routing on this platform. Please use the Quality of Service
feature instead. This action on the specified route map will be ignored.
Explanation
The switch does not support QoS services that are implemented using PBR route maps.
The PBR route map that is specified will be loaded, but references to QoS services will be ignored.
Recommended Action Use the QoS policy maps and class maps to configure this feature.
Error Message C4K_IOSIPROUTEMAN-3-VRFMANNOMOREVRFS: VrfMan: VPN routing forwarding
resources exhausted.
Explanation
The VPN routing forwarding resources have been exhausted.
Recommended Action Reduce the total number of VPNs in the switch.
Error Message C4K_IOSIPROUTEMAN-3-WCCPINVALIDMASKASSIGNMENTTABLE: Invalid mask
assignment table received for WCCP service group [char]
Explanation
The number of distinct masks in the new mask assignment table is more the maximum
number supported for a service group on the switch. The new table is discarded. Since a valid mask
assignment table is not available anymore, the service group cannot redirect traffic. All the traffic
that was expected to be redirected is now routed normally.
Recommended Action Make sure that the cache engine is correctly configured to send a valid mask
assignment table to the switch.
IOSIPROUTEMAN-4
Error Message C4K_IOSIPROUTEMAN-4-WCCPUNCHANGEDMASKASSIGNMENTTABLE: Mask assignment
table update received but the table has not changed for WCCP service group [char]
Explanation
The service group has received a new mask assignment table identical to the current
table. This could be due to a misconfiguration on the content engine side. The table change
indication will be ignored and the service group continues to use the current table for redirection.
Recommended Action Please check the configuration on the content engine side to make sure that this
unnecessary update does not get sent. If the configuration looks correct and the content engine is not
sending the same table repeatedly but you still see this message, please contact your technical
support representative.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E