EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
2-68
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
LINECARDMGMTPROTOCOL Messages
LINECARDMGMTPROTOCOL Messages
This section contains the module management protocol (LINECARDMGMTPROTOCOL) messages.
Error Message C4K_LINECARDMGMTPROTOCOL-3-FAILEDTOSEND: EsmpDriver [char] - Failed to
send ESMP requests due to [char].
Explanation
This message indicates a failure in ESMP request generation for the reason given. This
is probably due to high CPU utilization caused by a number of factors, and under these
circumstances switching module communication protocol packets can not be transmitted.
Recommended Action If you see this message frequently, analyze the traffic going to the CPU and
contact your technical support representative to debug the problem.
Error Message C4K_LINECARDMGMTPROTOCOL-4-INITIALTIMEOUTWARNING:
[char] - management request timed out.
Explanation
There are communication problems with the module ASIC that fans out a single gigabit
port to front-panel ports. A few messages are within tolerance levels.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_LINECARDMGMTPROTOCOL-4-ONGOINGTIMEOUTWARNING:
[char] - consecutive management requests timed out.
Explanation There are persistent communication problems with the module ASIC that fans out a
single gigabit port to front-panel ports.
Recommended Action Reinsert the module.
LINECARDMGMTPROTOCOL Messages
This section contains the LAN Port IP (LPIP) dynamic host policies (LPIPMAN) messages.
Error Message C4K_LPIPMAN-4-OUTOFMEMORY: Memory for constructing ACLs is not
available.
Explanation System memory is not available to set up LPIP dynamic host policies. LPIP host policies
do not work if this log message appears.
Recommended Action To correct this problem either free some memory on the switch or upgrade the
switch with additional RAM.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals