EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
2-48
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSIPROUTEMAN Messages
Error Message C4K_IOSINTF-5-TXPKTDROPONETHERCHANNEL:Dropping transmit packet out of
interface [char]
Explanation
A packet that should be transmitted out of a port channel was dropped during transitions
in the port channel membership. This condition occurs when a packet is transmitted out of the
aggregate port by higher layer protocols, but the software cannot find the specific state information
or when physical ports transition into or out of the port channel membership.
Recommended Action If the problem persists, contact your technical support representative.
IOSIPROUTEMAN Messages
This section contains the Catalyst 4500 series Cisco IOS IP Route Manager (IOSIPROUTEMAN)
messages.
IOSIPROUTEMAN-3
Error Message C4K_IOSIPROUTEMAN-3-ADJMANNOMOREADJS:AdjMan:
hardware adjacency resources exhausted, performance may be degraded.
Explanation
The hardware adjacency resources have been exhausted. The supervisor engine will
forward packets to this adjacency in the software. This action will likely represent a significant
performance degradation.
Recommended Action Reduce the number of adjacencies that are loaded into the routing table, and
then clear the IP routing table.
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBADJ:IOS IP Route Manager:No
memory available to allocate FIB Adjacency for [object-info]
Explanation
The switch does not have sufficient memory to allocate space for this adjacency; the
supervisor engine will forward it in the software instead.
Recommended Action Reconfigure the network so that there are fewer hosts that are directly adjacent
to the Catalyst 4500 series switch, and then clear and reload all of the routes (or reboot) so that the
adjacent hosts that were being sent to the software get reloaded.
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBENTRY:IOS IP Route Manager:No
memory available to allocate FIB Entry for [ip-addr]
Explanation The switch has insufficient memory to allocate space for the route that is associated with
this network.
Recommended Action Contact your technical support representative because memory leaks might
exist.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals