Cisco Catalyst 4500 Series Message Guide

2-47
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSINTF Messages
Error Message C4K_IOSINTF-5-OUTPACLDISABLEDUETOVACL: Output PACL [char] is disabled
on port [char]
Explanation
If the port is configured for a VLAN that has output RACL, then the output PACL on
the port is disabled. Output RACL and output PACL are mutually exclusive, it is not possible to
configure both simultaneously.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSINTF-5-STALEPHYPORT: Dropping packets to be transmitted out on
port [char] ( Linecard in Slot [dec] may have been removed )
Explanation
During hot-swapping operations a previously queued packet may be transmitted after a
switching module is removed. This indicates such packets are being dropped.
Recommended Action If this message appears without any hot swapping, please contact your
technical support representative.
Error Message C4K_IOSINTF-5-RJ45ACTIVE: Slot= [dec] Port= [dec]: RJ45 connector has
become active
Explanation
A dual media port changed from using the SFP connector to using the RJ-45 connector.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSINTF-5-RJ45INACTIVE: Slot= [dec] Port= [dec]: RJ45 connector
has become inactive
Explanation
A dual media port changed from using the RJ-45 connector to the SFP connector.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSINTF-5-TXL3PKTONPHYPORT:Transmitting L3 packet on a physical
port [char] that is part of [char] ([dec] packets). Make sure the physical port
in the L3 port channel does not have an ip addresses configured on it.
Explanation
Layer 3 protocols operate at the logical, not the physical, port level. Layer 3 protocol
packets were sent on a physical port that is part of a bundle. This condition occurs if there is a
misconfiguration; a physical port that is part of a Layer 3 port channel might have been assigned an
IP address.
Recommended Action Verify that the physical interface in the Layer 3 port channel does not have an
IP address that is assigned to it.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E