EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
2-46
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSINTF Messages
Error Message C4K_IOSINTF-5-GBICREMOVED: Slot= [dec] Port= [dec]: GBIC has been
removed
Explanation
An approved-vendor GBIC or SFP was removed.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSINTF-5-NOPRIMARYVLANASSOCIATION:Packet received on interface
[char] in vlan [dec] without primary vlan association. [mac-addr] will not be
secured.
Explanation
The switch received a packet on a secondary VLAN which does not have a primary
VLAN association. The switch will not secure a MAC address in this situation.
Recommended Action Associate this secondary VLAN with a valid primary VLAN.
Error Message C4K_IOSINTF-5-NOTXVLAN:Router Port [char] has no internal vlan
assigned to transmit packet
Explanation The specified Layer 3 interface does not have an assigned internal VLAN because
duplicate IP network assignments exist on different Layer 3 interfaces.
Recommended Action Remove the duplicate IP network that is configured on the interface. Assign the
correct IP network, and enter the no shutdown command on this interface.
Error Message C4K_IOSINTF-5-NOTXVLAN:Router Port [char] has no internal vlan
assigned to transmit packet
Explanation
Occasionally during hot-swapping operations a previously queued packet is transmitted
after the module in that slot was removed. Because the module no longer exists, the packets are
dropped.
Recommended Action If the problem persists even without any hot-swapping operations, contact your
technical support representative.
Error Message C4K_IOSINTF-5-OUTPACLDISABLEDUETORACL: Output PACL [char] is disabled
on port [char]
Explanation
If the port is configured for an SVI that has output RACL, then the output PACL on the
port is disabled. Output RACL and output PACL are mutually exclusive, it is not possible to
configure both simultaneously.
Recommended Action This is an informational message only. No action is required.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals