EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
2-64
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
L3HWFORWARDING Messages
L3HWFORWARDING Messages
This section contains the Layer 3 hardware forwarding (L3HWFORWARDING) messages.
L3HWFORWADING-2
Error Message C4K_L3HWFORWARDING-2-FWDCAMFULL:L3 routing table is full. Switching to
software forwarding.
Explanation
The hardware routing table is full; forwarding takes place in the software instead. The
switch performance might be degraded.
Recommended Action Reduce the size of the routing table. Enter the ip cef command to return to
hardware forwarding.
L3HWFORWARDING-3
Error Message C4K_L3HWFORWARDING-3-FTECONSISTENCYCHECKFAILED: FwdTableEntry
Consistency Check Failed: index [dec]
Explanation There was a consistency check failure. If this error occurs frequently, it could indicate
faulty hardware.
Recommended Action If the problem persists, contact your technical support representative.
Error Message C4K_L3HWFORWARDING-3-FWDCAMCONSISTENCYCHECKFAILED: FwdCam Consistency
Check Failed: index [dec]
Explanation
There is a FwdCam consistency check failure. If this error occurs frequently, it could
indicate faulty hardware.
Recommended Action If the problem persists, contact your technical support representative.
Error Message C4K_L3HWFORWARDING-3-FWDMEMPARITYERROR: Parity error in Forwarding
Memory
Explanation
There is a parity error in forwarding memory. This error message could indicate a
transient hardware problem or a more permanent problem.
Recommended Action If you see this message multiple times, reboot the switch.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals