Cisco Catalyst 4500 Series Message Guide

2-65
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
L3HWFORWARDING Messages
Error Message C4K_L3HWFORWARDING-3-MASKTABLECONSISTENCYCHECKFAILED: MaskTable
Consistency Check Failed: block [dec]
Explanation
There was a mask table consistency check failure. If this error occurs frequently, it could
indicate faulty hardware.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_L3HWFORWARDING-3-MASKTABLEREGIONCONSISTENCYCHECKFAILED: MaskTable
Consistency Check Failed: region [object-info]
Explanation
There is a consistency check failure in the mask table. The error is located in the region
that is specified by [object-info].
Recommended Action This is an informational message only. No action is required.
Error Message C4K_L3HWFORWARDING-3-NOMOREK2FIBADJS:No hardware adjacency resource
available for route [ip-addr]
Explanation
The hardware adjacency table has insufficient memory to allocate the adjacency set for
this route. Forwarding will take place in the software instead.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_L3HWFORWARDING-3-PBRBLOCKFAILEDTOADDFLATACE:K2FibPbrBlock:failed
to add FlatAce [object-info] to block [dec]
Explanation
The policy-routing data structures are corrupted. This memory corruption will probably
crash the switch soon.
Recommended Action Contact your technical support representative.
Error Message C4K_L3HWFORWARDING-3-PBRBLOCKFAILEDTODELETEFLATACE:K2FibPbrBlock:
failed to remove FlatAce [object-info] from block [dec]
Explanation The policy-routing data structures are corrupted. This memory corruption will probably
crash the switch soon.
Recommended Action Contact your technical support representative.
Error Message C4K_L3HWFORWARDING-3-PBRFLATTENINGFAILED: Software resource
exhaustion trying to load route-map for interface [char] ( [dec] ), elapsed
time is [object-info] us
Explanation
The switch has insufficient memory to process the access list for a route map.
Recommended Action This is an informational message only. No action is required.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E