Cisco Catalyst 4500 Series Message Guide

2-28
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
EBM Messages
Error Message DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port
[char] because of VTP domain mismatch.
Explanation
The two ports involved in trunk negotiation belong to different VTP domains. Trunking
is possible only when the ports involved belong to the same VTP domain.
Recommended Action Reconfigure the switch to ensure that the two ports that are involved in trunk
negotiation belong to the same VTP domain.
EBM Messages
This section contains the Ethernet bridge management (EBM) messages.
EBM-3
Error Message C4K_EBM-3-CANTALLOCATEEBMPORT:No EbmPort memory to allocate EbmPort
for PimPort [char]
Explanation
There is insufficient memory for information that is associated with the specified port.
Recommended Action Install additional memory.
Error Message C4K_EBM-3-CANTALLOCATEIENODE:No interposition table memory to add
entry for addr %ea
Explanation
There is insufficient memory for this internal data structure.
Recommended Action Install additional memory.
Error Message C4K_EBM-3-CANTALLOCATEHOSTCHECKPOINTMESSAGE: Cannot allocate memory
for host checkpoint message. Layer2 host redundancy on standby will be out-of-sync
with active.
Explanation
There is insufficient memory to allocate space for this internal data structure.
Recommended Action You may need to install additional memory in both supervisor engines.
Error Message C4K_EBM-3-CANTALLOCATEIGMPGROUPENTRY:No igmp group memory to add new
group entry for addr [mac-addr]
Explanation This error occurs if you have created a large number of IGMP groups and there is
insufficient memory to support additional Internet Group Management Protocol (IGMP) group
entries.
Recommended Action Either install additional memory, or reduce the number of IGMP groups.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E