EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
2-43
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSDIAGMAN Messages
Error Message C4K_IOSACLMAN-4-MOLACLFEATUREALLOCFAILURE: Mol AclFeature Allocation
for Mol Acl: [dec] is failed
Explanation
A new MOL ACL was created but there was insufficient memory for a MOL ACL. The
ACL was not applied.
Recommended Action Remove all configurations where the MOL ACL is used as an IP ACL before
configuring a MOL ACL with the same name.
Error Message C4K_IOSACLMAN-4-VLANMAPOUTOFMEMORY: Could not add an entry to Vlan Map
[char]. Out of memory
Explanation
The system has insufficient memory to allocate a new entry for this VLAN map.
Recommended Action Remove all configurations where the ACL is used as an IP ACL before
configuring a MAC ACL with the same name.
IOSDIAGMAN Messages
This section contains the Catalyst 4500 series Cisco IOS Diagnostic Manager (IOSDIAGMAN)
messages.
Error Message C4K_IOSDIAGMAN-4-CANNOTRUNTESTNOTPORTFAILEDBOOTUP: Cannot run the
diag test as port failed bootup tests
Explanation The online diagnostic test requested cannot be run on this port because the port failed
bootup tests.
Recommended Action Investigate why the bootup tests have failed on the port. The module or the port
may be damaged.
Error Message C4K_IOSDIAGMAN-4-TESTNOTSUPPORTEDONMODULE: [char] is not supported on
this module
Explanation
The online diagnostic test requested is not supported on this module.
Recommended Action If the diagnostic test is required, consider upgrading to hardware that supports
the test.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals