EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
2-60
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IPROUTEMAN Messages
Error Message C4K_IOSSYSMAN-4-NOSPACEFORENVVAR: Env. variable [char] cannot be set:
no space
Explanation
The software writes certain configuration values to the NVRAM. The switch has
insufficient memory to write an environment variable.
Recommended Action Boot the system into ROMMON mode. At the ROMMON prompt, enter the
unset command to remove the unused environment variables to reclaim the space.
IPROUTEMAN Messages
This section contains the Catalyst 4500 series Cisco IOS IP Routing Manager (IPROUTEMAN)
messages.
IPROUTEMAN-3
Error Message C4K_IPROUTEMAN-3-CANTALLOCATEIPETHERADDRENTRY:IP Route Manager:No
memory to add Router Port MAC Address, numInUse: [dec]
Explanation
Each router port in the system can listen to secondary MAC addresses as the “router’s
MAC address,” which is a process that is useful for protocols like Hot Standby Routing Protocol
(HSRP). The system does not have sufficient memory to hold a secondary MAC address.
Recommended Action Boot the switch into ROMMON mode. At the ROMMON prompt, enter the
unset command to remove the unused environment variables to reclaim the space.
Error Message C4K_IPROUTEMAN-3-FIBADJMANDUPLICATEADJ:FIB Entry:Tried to create a
duplicate adj for key [object-info]
Explanation
A request was made to add a duplicate adjacency to the Forwarding Information Base
(FIB) adjacency database.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-FIBADJMANINUSEDELETION:FIB Adjacency
Manager:Attempted to delete FIB Adjacency Id [dec] which is in use
Explanation A request was made to delete an adjacency from the Forwarding Information Base (FIB)
database while that adjacency was still referenced by a routing table entry.
Recommended Action This is an informational message only. No action is required.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals