Cisco Catalyst 4500 Series Message Guide

2-11
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
CHASSIS Messages
CHASSIS-4
Error Message C4K_CHASSIS-4-CANTWRITESUPERVISORSPROM:Writing the supervisor's SPROM
is not supported
Explanation
Rewriting the supervisor engine’s serial programmable read-only memory (SPROM) is
not allowed, because if it is done incorrectly, it could make the system unusable.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_CHASSIS-4-INLINEPOWERRESTORED:Resuming normal phone operation
since inline power has been restored
Explanation
PoE to the switch was restored, and normal phone operation will resume.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_CHASSIS-4-OVERHEATINGOVER:Resuming normal operation after return
to acceptable temperatures.
Explanation The unit’s modules were reset to reduce heat generation, because the unit reached a
critical temperature. The switch is now cool enough to return to normal operation.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_CHASSIS-4-SUFFICIENTFANSRESTORED: Resuming normal operation after
restoration of adequate fan cooling
Explanation
The modules were reset to reduce heat generation because there were not enough
working fans. Adequate fan cooling is now restored, and the switch will resume normal operation.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_CHASSIS-4-SUFFICIENTMODULEPOWERRESTORED:Module in slot [dec]
resuming normal operation after restoration of adequate power
Explanation
The module was reset to conserve power because the system had inadequate power
available. The switch now has adequate power and is resuming normal operation.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_CHASSIS-4-SUFFICIENTPOWERRESTORED:Resuming normal operation after
restoration of adequate power
Explanation The switch reset the modules to conserve power, but it now has adequate power and will
resume normal operation.
Recommended Action This is an informational message only. No action is required.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E