2-110
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
SWITCHINGENGINEMAN Messages
Error Message SW_VLAN-6-VTP_MODE_CHANGE: VLAN manager changing device mode from
[char] to [char].
Explanation
Some switch devices must automatically change VTP device modes upon receipt of a
VLAN configuration database containing more than a set number of VLANs, depending on the
device. Such a spontaneous conversion occurred, what the previous mode was, and what the current
mode is.
Recommended Action This is an informational message only. No action is required.
SWITCHINGENGINEMAN Messages
This section contains the switching engine management (SWITCHINGENGINEMAN) messages.
SWITCHINGENGINEMAN-2
Error Message C4K_SWITCHINGENGINEMAN-2-PACKETMEMORYERROR3: Persistent Errors in
Packet Memory [dec]
Explanation
There is a high rate of persistent errors in packet memory. This condition might indicate
a persistent hardware problem.
Recommended Action If this message persists, use the show platform commands to show results,
contact your technical support representative, and provide the representative with the gathered
information.
SWITCHINGENGINEMAN-3
Error Message C4K_SWITCHINGENGINEMAN-3-BADDELIMITER:Recived CPU packet with bad
delimiter
Explanation
The software expected a delimiter pattern of successive packets but received some other
pattern. This condition might be due to a loss of synchronization between the hardware and the
software.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_SWITCHINGENGINEMAN-3-BADLENGTH:Recived CPU packet with bad length
Explanation
The switch received a CPU packet that was either too long or too short.
Recommended Action This is an informational message only. No action is required.