EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
2-34
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
HW Messages
Error Message C4K_FLASH-4-COMPACTFLASHNOTREADY: Compact flash is not ready
Explanation
You may see this message if the compact flash is not inserted properly or if it is removed
while the switch is trying to access the flash.
Recommended Action Reinsert the compact flash and retry the operation.
HW Messages
This section contains the hardware (HW) messages.
Error Message C4K_HW-3-S2WERROR:[char] [char] [dec] Error: [object-info] Device
Addr: [dec] Mem Addr: [object-info] Value: [dec]
Explanation
An unexpected error occurred when the switch accessed the hardware device specified
in the message.
Recommended Action Contact your technical support representative.
Error Message C4K_HW-3-X2IDENTIFICATIONFAILURE:Error while trying to identify serdes
type for [char] ( [dec] ) X2 module
Explanation
There was an error when trying to identify the X2 module type.
Recommended Action Contact your technical support representative. You will probably need to
replace the supervisor engine.
Error Message C4K_HW-3-X2OUIREGREADFAILURE:Error while reading Supervisor X2 OUI
register Device Addr: [dec]
Explanation
There was an unexpected error when accessing a hardware device with the given device
address.
Recommended Action Contact your technical support representative. You will probably need to
replace the supervisor engine.
Error Message C4K_HW-3-X2LOOPBACKFAILURE: Failed to put [char] Xaui([dec]) [char]
loopback
Explanation Software was unable to put the X2 in or out of loopback because it was unable to
determine the X2 type.
Recommended Action This is an informational message only. No action is required.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals