Cisco Catalyst 4500 Series Message Guide

2-45
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IOSINTF Messages
IOSINTF Messages
This section contains the Catalyst 4500 series Cisco IOS interface operation (IOSINTF) messages.
IOSINTF-4
Error Message C4K_IOSINTF-4-DYNAMICPOLICYMEMOVERFLOW: Dynamic policy memory
exhausted - [char] policy for host %i on port [char] not fully applied.
Explanation
The memory allocated for dynamic host policies (dynamic ACLs and URL redirection)
has been completely used. The policy for the host and interface specified is not fully applied by the
platform. Traffic from the host on that interface may hit the default PACL instead.
Recommended Action Reduce either the number of hosts on the system with dynamic host policies or
the size of the dynamic policies being applied.
Error Message C4K_IOSINTF-4-INTVLANALLOCFAIL:Failed to allocate internal VLAN for
interface [char]. The interface will remain down.
Explanation
When a routed port or port channel interface is enabled, it must map to an internal
VLAN in order to operate. If there are no internal VLANs available when an interface is enabled,
the interface remains down and this message is logged.
Recommended Action An internal VLAN can be freed by disabling some other routed port or port
channel interface or by deleting a user-configured VLAN in the 1006 to 4094 range. Once a VLAN
is made available, the interface will come up if it is disabled and reenabled.
Error Message C4K_IOSINTF-4-REFLEXIVEACLNOTSUPPORTED: Reflexive Acls are not
supported. Ignoring the [char] entry.
Explanation
The reflexive ACLs are not supported. ACEs with the evaluate and reflect keywords
are ignored.
Recommended Action Do not configure ACEs with the evaluate or reflect keywords.
IOSINTF-5
Error Message C4K_IOSINTF-5-GBICINSERTED: Slot= [dec] Port= [dec]: GBIC has been
inserted
Explanation
An approved-vendor GBIC or SFP was inserted.
Recommended Action This is an informational message only. No action is required.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E