2-103
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
SWITCH-QOS-TB Messages
SUPERVISOR-7
Error Message C4K_SUPERVISOR-7-BACKPLANESEEPROMWRITEFAILED:Failed to write
backplane's serial eeprom
Explanation
The writing of the backplane serial EEPROM failed.
Recommended Action Power cycle the switch.
Error Message C4K_SUPERVISOR-7-SEEPROMWRITEFAILED:Failed to write supervisor’s
serial eeprom
Explanation
The software was unable to write to the supervisor engine serial EEPROM.
Recommended Action Remove and reinsert the module. If this message reappears, reboot the switch.
If the switch is still unable to write to the EEPROM, contact your technical support representative.
SWITCH-QOS-TB Messages
This section contains the Switch QoS Manager (SWITCH-QOS-TB) messages.
Error Message SWITCH_QOS_TB-5-TRUST_DEVICE_DETECTED: [char] detected on port [char]
Explanation
Software detected that a device matching the trusted device boundary setting for the
interface and changed the trust state for the interface to trusted.
Recommended Action This is an informational message only. No action is required.
Error Message SWITCH_QOS_TB-5-TRUST_DEVICE_LOST: [char] no longer detected on port
[char], port set to untrusted
Explanation
The system lost contact with a trusted device and changed the trust state for the interface
to untrusted.
Recommended Action This is an informational message only. No action is required.