EasyManuals Logo

Cisco Catalyst 4500 Series Message Guide

Cisco Catalyst 4500 Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
2-86
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
REDUNDANCY Messages
REDUNDANCY-4
Error Message C4K_REDUNDANCY-4-CONFIGSYNCFAIL:Persistent-config Sync to Standby
supervisor failed.
Explanation
The active supervisor engine failed to receive a confirmation message from the standby
supervisor engine. There is a potential problem with the standby supervisor engine.
Recommended Action Contact your technical support representative.
Error Message C4K_REDUNDANCY-4-KEEPALIVE_WARNING: Keepalive messages from peer
Supervisor are missing for [dec] seconds
Explanation
Keepalive messages have not been sent from the peer supervisor engine. If the situation
persists and the keepalive messages do not resume, the peer supervisor engine will eventually be
reset. This message is logged for every third missed keepalive message.
Recommended Action This is an informational message only. No action is required.
REDUNDANCY-5
Error Message C4K_REDUNDANCY-5-CALENDAR: The calendar has been successfully
synchronized to the standby supervisor for the first time
Explanation
The calendar was successfully synchronized to the standby supervisor engine for the
first time.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_REDUNDANCY-5-CALENDAR_RATELIMIT: The calendar has been
successfully synchronized to the standby supervisor [dec] times since last
calendar syslog
Explanation
The calendar was successfully synchronized to the standby supervisor engine the
specified number of times.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_REDUNDANCY-5-CONFIGSYNC:The [char] has been successfully
synchronized to the standby supervisor
Explanation The configuration was successfully synchronized to the standby supervisor engine.
[char] can be either a private configuration or a startup configuration.
Recommended Action This is an informational message only. No action is required.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals