Cisco Catalyst 4500 Series Message Guide

2-61
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
IPROUTEMAN Messages
Error Message C4K_IPROUTEMAN-3-FIBADJMANNONEXISTENTDELETION:FIB Adjacency
Manager:Attempted to delete FIB Adjacency Id [dec] which does not exist
Explanation
A request was made to delete an adjacency from a platform Forwarding Information
Base (FIB) that does not exist.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-FIBDUPLICATEENTRY:FIB:Attempt to create a duplicate
FIB Entry for [ip-addr]
Explanation
A request to add a duplicate routing table entry to the Forwarding Information Base
(FIB) database was detected.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-FIBENTRYNOSUCHADJTODELETE:FIB Entry:Couldn't delete
adj [ip-addr] from FIB Entry [ip-addr], no such adj.
Explanation
A request was made to delete an adjacency from a routing table entry in the platform
Forwarding Information Base (FIB), and the adjacency was not found.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-FIBENTRYTOOMANYADJ:FIBEntry: FIB Entry: Too many
adjacencies on FIB Entry for [ip-addr], tried to add adj [ip-addr]
Explanation
A request was made to add another adjacency to a routing table entry in the platform
Forwarding Information Base (FIB) when that entry was already at the maximum allowed value.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-FIBNONEXISTENTDELETION:FIB:Attempted to delete FIB
Entry Id [dec] which does not exist
Explanation A request was made to delete a nonexistent routing table entry from the platform
Forwarding Information Base (FIB).
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IPROUTEMAN-3-NOMOREK2FIBADJS:K2FibUnicast:no more K2FibAdjs
available, using punt adj instead for [ip-addr] route.
Explanation
The hardware resources for adjacencies have been exhausted; switching will take place
in the software instead. The switch performance might be degraded.
Recommended Action This is an informational message only. No action is required.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E