Cisco Catalyst 4500 Series Message Guide

2-13
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
OL-11541-01
Chapter 2 Messages and Recovery Procedures
COMMONHWACLMAN Messages
Error Message C4K_COMMONHWACLMAN-4-FAILEDTOSWITCHPORTTAGS:Failed to switch port
tags, old tag: [object-info] new tag: [object-info] . Software paths: [dec]
Hardware paths: [dec]
Explanation
The software failed to switch tags. This error could be transient. The ACL that you were
trying to configure will not become active.
Recommended Action Detaching and reattaching the ACLs (and policies) might solve the problem.
Error Message C4K_COMMONHWACLMAN-4-FAILEDTOSWITCHVLANTAGS:Failed to switch vlan
tags, old tag: [object-info] new tag: [object-info] . Software paths: [dec]
Hardware paths: [dec]
Explanation
The software failed to switch tags. This error could be transient. The ACL that you were
trying to configure will not become active.
Recommended Action Detaching and reattaching the ACLs (and policies) might solve the problem.
Error Message C4K_COMMONHWACLMAN-4-HWPROGSUCCESS: [char] [char] - now fully loaded
in hardware TCAM
Explanation
ACL-based features are now successfully loaded. Packets that were previously
processed in software due to a prior loading failure will now be processed in hardware. If the feature
is a policy map, then QOS will be reenabled on the specific interface.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_COMMONHWACLMAN-4-OUTOFPATHS: Could not allocate path for
( [object-info] )
Explanation There are too many ports or VLANs using ACLs. The ACLs might not work correctly.
Recommended Action Remove unnecessary ACLs from some interfaces.
Error Message C4K_COMMONHWACLMAN-4-OUTOFTAGS:No more free tags available for path
( [object-info] )
Explanation
All available tags are being used or are about to be used. Because you have configured
either too many features using ACLs or features using ACLs that are attached to ports or VLANs,
the hardware forwards the packets to CPU for ACL processing.
Recommended Action Remove unnecessary ACLs from some interfaces.
Error Message C4K_COMMONHWACLMAN-4-PERMITALL: Out of resources for Qos, permit all
for [object-info]
Explanation
The switch is running out of hardware CAM resources. All packets are permitted, and
QoS is applied.
Recommended Action Remove unnecessary ACLs from some interfaces.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E