Cisco cBR 8 - Hardware Compatibility Matrix for the Cisco Cbr Series Routers; Prerequisites for Usage-Based Billing (SAMIS)

Hardware Compatibility Matrix for the Cisco cBR Series Routers
The hardware components that are introduced in a given Cisco IOS-XE Release are supported in all
subsequent releases unless otherwise specified.
Note
Table 22: Hardware Compatibility Matrix for the Cisco cBR Series Routers
Interface CardsProcessor EngineCisco CMTS Platform
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 CCAP Line Cards:
• PID—CBR-LC-8D30-16U30
• PID—CBR-LC-8D31-16U30
• PID—CBR-RF-PIC
• PID—CBR-RF-PROT-PIC
• PID—CBR-CCAP-LC-40G-R
Cisco cBR-8 Downstream PHY
Modules:
• PID—CBR-D30-DS-MOD
• PID—CBR-D31-DS-MOD
Cisco cBR-8 Upstream PHY
Modules:
• PID—CBR-D30-US-MOD
• PID—CBR-D31-US-MOD
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 Supervisor:
• PID—CBR-SUP-250G
• PID—CBR-CCAP-SUP-160G
• PID—CBR-CCAP-SUP-60G
• PID—CBR-SUP-8X10G-PIC
Cisco cBR-8 Converged
Broadband Router
Prerequisites for Usage-Based Billing (SAMIS)
The Usage-based Billing feature has the following prerequisites:
•
Cable modems must be compliant with DOCSIS 1.0 or DOCSIS 2.0, OSSI version 3.0 and DOCSIS
3.0.
•
Cable modems that are being monitored should use a DOCSIS configuration file that defines upstream
and downstream primary service flows using Service Class Naming (SCN [TLV 24/25, subTLV 4]). If
dynamically-created service flows are to be monitored, they should also be created with SCN names.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
122
Usage-Based Billing (SAMIS)
Hardware Compatibility Matrix for the Cisco cBR Series Routers