Cisco cBR 8 - Hardware Compatibility Matrix for the Cisco Cbr Series Routers; Prerequisites for Flap List Troubleshooting

Hardware Compatibility Matrix for the Cisco cBR Series Routers
The hardware components that are introduced in a given Cisco IOS-XE Release are supported in all
subsequent releases unless otherwise specified.
Note
Table 31: Hardware Compatibility Matrix for the Cisco cBR Series Routers
Interface CardsProcessor EngineCisco CMTS Platform
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 CCAP Line Cards:
• PID—CBR-LC-8D30-16U30
• PID—CBR-LC-8D31-16U30
• PID—CBR-RF-PIC
• PID—CBR-RF-PROT-PIC
• PID—CBR-CCAP-LC-40G-R
Cisco cBR-8 Downstream PHY
Modules:
• PID—CBR-D30-DS-MOD
• PID—CBR-D31-DS-MOD
Cisco cBR-8 Upstream PHY
Modules:
• PID—CBR-D30-US-MOD
• PID—CBR-D31-US-MOD
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 Supervisor:
• PID—CBR-SUP-250G
• PID—CBR-CCAP-SUP-160G
• PID—CBR-CCAP-SUP-60G
• PID—CBR-SUP-8X10G-PIC
Cisco cBR-8 Converged
Broadband Router
Prerequisites for Flap List Troubleshooting
•
To configure and access the flap list using SNMP commands, you must be using an SNMPv3 manager
and have configured the Cisco CMTS router for SNMP operations.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
196
Flap List Troubleshooting
Hardware Compatibility Matrix for the Cisco cBR Series Routers