PurposeCommand or Action
Enters Call Home configuration mode.call-home
Example:
Router(config)# call-home
Step 4
Assigns customer's email address. You can enter a maximum
of 200 characters in email address format with no spaces.
contact-email-addr email-address
Example:
Router(cfg-call-home)# contact-email-addr
username@example.com
Step 5
You can use any valid email address. You cannot use
spaces.
Note
(Optional) Configures a Simple Mail Transfer Protocol (SMTP)
email server address for Call Home. This command is only used
mail-server {ipv4-address | name} priority number
Example:
Router(cfg-call-home)# mail-server 10.1.1.1
priority 4
Step 6
when sending email is part of the actions that are defined in any
DS.
Enters the Call Home destination profile configuration mode
for the specified destination profile. If the specified destination
profile does not exist, it is created.
profile name
Example:
Router(cfg-call-home)# profile profile1
Step 7
(Optional) Enables the message transport method.destination transport-method {email | http}
Step 8
Example:
Router(cfg-call-home-profile)# destination
transport-method email
• email—Sets the email message transport method.
• http—Sets the HTTP message transport method.
To configure diagnostic signatures, you must use the
http option.
Note
Configures the destination email address or URL to which Call
Home messages are sent.
destination address {email email-address | http url}
Example:
Router(cfg-call-home-profile)# destination
address http https://tools.cisco.com/its/
service/oddce/services/DDCEService
Step 9
To configure diagnostic signatures, you must use the
http option.
Note
Subscribes this destination profile to the Inventory alert group.
The Inventory alert group can be configured for periodic
notification.
subscribe-to-alert-group inventory [periodic {daily
hh:mm | monthly date hh:mm | weekly day hh:mm}]
Example:
Router(cfg-call-home-profile)#
subscribe-to-alert-group inventory
periodic daily 12:00
Step 10
This command is used only for the periodic
downloading of DS files.
Note
What to Do Next
Set the configured profile from the previous procedure as the DS profile and configure other DS parameters.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
35
Call Home
How to Configure Diagnostic Signatures
To Next Page
Loading...
Need help?
General
